Error code · Range

Dacor Classic ERC Oven and Range Code F4: Open Oven Sensor Circuit

Medium · inspection needed

Code: F4
Appliance: Range
Brand: Dacor
Warranty: 30-day workmanship

What F4 means

Where classic Dacor wall ovens and ranges use the ERC electronic control, -F4- tells you the oven sensor circuit is open, as if the sensor were disconnected. The control saw an open circuit on 16 consecutive readings, and it checks only while the oven is cooking. When it sets the alarm, the control beeps and the bake modes are disabled. The ERC is used in the ERSD, PCS/D, RSD, RSE, RSG, MCS/D and ECS/D families, and many of these ovens are still in service.

Common causes of F4

A broken or disconnected oven sensor wire
A loose or corroded sensor connector
An oven sensor that has gone open inside
The ERC input that reads the sensor

✓ One safe check you can try

1. Touch Cancel to stop the beeping and let the oven cool completely. 2. Do not pull on or bend the sensor probe inside the oven. 3. Avoid starting a bake cycle until the oven has been checked, since the bake modes are disabled by this alarm. 4. Call us to have the sensor circuit tested.

! Why to stop there

An open circuit can sit in the sensor, in its wiring or in the connector, and none of them can be told apart from the front of the oven.
We measure the sensor circuit with the oven cold and check the connector, so the part we replace is the one behind the problem.
If a part for your older ERC oven is hard to find, we say so before booking the repair.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Range codes

C-F0Dacor Range Code C-F0: Boards Stopped Communicating C-F2Dacor Range Code C-F2: Touch Control Link Lost C-F5Dacor Induction Range Code C-F5: Display Link Interrupted C-F6Dacor Induction Range Code C-F6: Main and Sub Board Link Lost C-F7Dacor Induction Range Code C-F7: Oven and Cooktop Board Not Talking Door-not-shut error message (self-clean)Dacor Discovery Range Door-Not-Shut Message During Self-Clean: Door Open E2Dacor Heritage Induction Range Code E2: Cook Zone Too Hot F0Dacor Classic ERC Oven and Range Code F0: Shorted or Jammed Input Device

F4F4 questions

What does -F4- mean on a Dacor oven?

The ERC sees an open oven sensor circuit, which means a break somewhere between the control and the sensor. It beeps and disables bake modes until the circuit is repaired.

How is F4 different from F3?

F3 is a shorted sensor circuit and F4 is an open one. Both appear only while cooking and both stop the control from reading oven temperature, but the cause and the repair can differ.

Can I still use the broiler or other modes?

We advise leaving the oven off until we check it. The alarm disables the bake modes, and cooking without a working temperature sensor is a poor idea for the oven and your food.

Book a visit

Still seeing F4?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 231-9708