Error code · Range

Dacor Range Code C-F2: Touch Control Link Lost

Medium · inspection needed

Code: C-F2
Appliance: Range
Brand: Dacor
Warranty: 30-day workmanship

What C-F2 means

The C-F2 code is shared by two Dacor platforms but names a different link on each. On the DOP48C96DLS range, it means communication between the main board and the touch control was interrupted. On the DOP30T940IS induction range, it means communication between the touch control and the secondary board was interrupted. You see C-F2 on the display, and the touch controls may stop responding.

Common causes of C-F2

The cable or connector at the touch control
The touch control panel
The main or secondary board it talks to

✓ One safe check you can try

1. Put the knob at Off, then bring the range up again. 2. If C-F2 comes back, turn off the breaker feeding the range for 30 seconds or longer, then turn it on. 3. If the code stays, call us, and we will confirm a three-hour arrival window.

! Why to stop there

Which link failed differs by model, so we start by confirming whether you have the DOP48C96DLS or the DOP30T940IS.
A lost link can be the touch panel, a connector or a board, and we test each before we replace one.
We quote in writing before starting, and the repair is backed for 30 days.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Range codes

C-d1Dacor Oven Door Lock Code C-d1: Lock Position C-F0Dacor Range Code C-F0: Boards Stopped Communicating C-F5Dacor Induction Range Code C-F5: Display Link Interrupted C-F6Dacor Induction Range Code C-F6: Main and Sub Board Link Lost C-F7Dacor Induction Range Code C-F7: Oven and Cooktop Board Not Talking Door-not-shut error message (self-clean)Dacor Discovery Range Door-Not-Shut Message During Self-Clean: Door Open E2Dacor Heritage Induction Range Code E2: Cook Zone Too Hot F0Dacor Classic ERC Oven and Range Code F0: Shorted or Jammed Input Device

C-F2C-F2 questions

Which link does C-F2 report?

A link between the touch control and a control board was interrupted. On the DOP48C96DLS it is the main board, and on the DOP30T940IS it is the secondary board.

Why is my touch control not responding?

With C-F2, the touch control and the board lost contact, so presses do not reach the range. A restart may restore it briefly.

Is C-F2 an expensive repair?

It depends on whether the cause is a connector, the panel or a board. We give a written price first and say plainly if it is not worth it.

Book a visit

Still seeing C-F2?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 231-9708